An instrument for the transmission of articulate speech by the electric
current. The current is defined as of the undulatory type. (See Current,
Undulatory.)
The cut shows what may be termed the fundamental
telephone circuit. A
line wire is shown terminating in ground plates and with a
telephone in
circuit at each end. The latter consists of a magnet N S with a coil of
insulated wire H surrounding one end. Facing the pole of the magnet is a
soft iron diaphragm D, held in a frame or mouthpiece T. Any change of
current in the line affects the magnetism of the magnet, causing it to
attract the diaphragm more or less. The magnet and diaphragm really
constitute a little electric motor, the diaphragm vibrating back and
forth through an exceedingly short range, for changes in the magnetic
attraction.
The principle of the reversibility of the dynamo applies here. If the
magnet is subjected to no change in magnetism, and if the diaphragm is
moved or vibrated in front of its poles, currents will be induced in the
wire bobbin which surrounds its end. If two such magnets with bobbins
and diaphragms are arranged as shown, vibrations imparted to one
diaphragm will send currents through the line which, affecting the
magnetism of the distant magnet, will cause its diaphragm to vibrate in
exact accordance with the motions of the first or motor diaphragm. In
the combination one
telephone represents a dynamo, the other a motor.
If the vibrations of the diaphragm are imparted by the voice, the voice
with all its modulations will be reproduced by the
telephone at the
distant end of the line.
Fig. 324. DIAGRAM OF BELL TELEPHONES
AND LINE WITH EARTH CONNECTIONS.
Fig. 325. SECTION OF BELL
TELEPHONE.
The above gives the essential features of the Bell
telephone. In
practice the
telephone is used only as the receiver. As transmitter a
microphone is employed. To give the current a battery, generally of the
open circuit type, is used, and the current in the line is an induced or
secondary one.
The microphone which is talked to, and which is the seat of the current
variations which reproduce original sound, is termed the transmitter,
the
telephone in which the sounds are produced at the distant end of the
line is termed the receiver.
Fig. 325 shows the construction of the Bell
telephone in universal use
in this country as the receiver. M is a bar magnet, in a case L L. B B
is a bobbin or coil of insulated wire surrounding one end of the magnet.
D is the diaphragm of soft iron plate (ferrotype metal), and E is the
mouthpiece. The terminals of the coil B B connect with the binding
screws C C. The wire in the coil is No. 36, A. W. G., and is wound to a
resistance of about 80 ohms.
As typical transmitter the Blake instrument may be cited. It is a carbon
microphone. It is shown in section in the cut; a is the mouthpiece and e
is a diaphragm of iron plate, although other substances could be used; f
is a steel spring, with a platinum contact piece at its end. One end
bears against the diaphragm, the other against a carbon block k. The
latter is carried by a brass block p, and pressure is maintained between
these contacts by the spring g and weight of the piece c, which by
gravity tends to press all together. The current passes by way of the
spring f, carbon button k and spring g through the circuit indicated.
A battery is in circuit with these parts. If a
telephone is also in
circuit, and the transmitter is spoken against, the diaphragm vibrating
affects the resistance of the carbon-platinum contact, without even
breaking the contact, and the
telephone reproduces the sound. The heavy
piece of metal C acts by its inertia to prevent breaking of the contact.
The position of this piece c, which is carried by the brass plate m, is
adjusted by the screw n.
Fig. 326. SECTION OF BLAKE TRANSMITTER.
In practice the transmitter and battery are usually on a local circuit,
which includes the primary of an induction coil. The line and distant
receiving
telephone are in circuit with the secondary of the induction
coil, without any battery.